Did You Know That Over 50% of homes have mold issues* but only 5% are tested during home inspections.
Traditional mold testing techniques are costly, take a lot of time, and don’t deliver on their promises, often with sub-standard or difficult-to-interpret reports.
Home Inspection Authority uses Sporecyte Lab AI powered mold testing for indoor air mold analysis and reports. Sporecyte analyzes 100% of samples while most competitors only analyze 30% of samples.
ISO/IEC 17025:2017 Accredited with PJLA
Sample Report Link: https://sporecyte.com/wp-content/uploads/2023/04/Sample-Report-1.pdf
If you or your family have sensitivities to air quality this testing service can detect any elevated spore levels in the air caused by visible or hidden mold. This service is recommended if any moisture stains or damage are observed or if any unidentified odors in any areas of the home or office are present.
Indoor air quality testing is our most requested service add on while performing a home inspection for piece of mind before moving into a new home. If you or your family have sensitivities to air quality this sampling/testing service may detect any elevated mold spore levels in the air caused by visible or hidden mold. This service is recommended if inspector observes any water or moisture stains or unidentified odors in any areas of the home or if seller has disclosed past or present leaks, mold or moisture intrusion conditions in building.
Surface And Air Sampling Information
Surface sample collection identifies what types of mold are found on a surface. Air sample collection identifies what types of mold spores are in the air and quantifies the amounts of each type. Air sample collection requires a minimum of two samples collected in order for the third party laboratory to have an outdoor control sample for comparative analysis. The indoor mold spore levels in your home should be similar to or lower than those in the outdoor environment.
(Minimum of 2 Indoor Air Samples and one Exterior Control sample is required for any home or business if air sampling service is requested). The square footage and layout of any building will dictate the number of samples recommended, this will be determined by the inspector onsite and a sampling protocol will be presented to you, you can then decide how many samples you want taken over and above the minimum of 3.
Surface samples are also available and will be included in the sampling protocol if visible mold is observed at time of inspection. Surface sampling only does not require air sampling however inspector will recommend air sampling in order to provide you with the most thorough inspection/testing service.
(Indoor air quality testing is outside the scope of a general home inspection and NOT included, It is offered as an additional service for a fee).
